Yes, the Swagman Exo Aero Rooftop Kayak Carrier # S65145, that you referenced will fit the Thule SquareBars like # TH712100.
This carrier is designed to hold 1 kayak or 1 canoe hull-side down, and is designed to fit most crossbars up to 2-1/2 inches wide. The minimum crossbar spread to accommodate this system is 24 inches. It also comes with tie-down straps for the front and the rear and also tie-down straps that secure the canoe to the roof rack. view full answer...
I would be happy to help you. A weight distribution hitch is only going to be affected by the tongue weight of your trailer so that is the only number you will want to account for when determining what system you need. Since your 2017 Riverside Retro 177SE has a GVWR of 3,500 lbs and a TW of 420 lbs. I recommend the Reese Straight Line item # RP66072 you referenced. This system has a tongue weight range of 200 lbs - 600 lbs which will be perfect for your trailer. You will also need the... view full answer...
The rear of the bed of a 2001-2006 Ford Explorer Sport Trac is right at 54-11/16 inches wide, while the rear width of the bed from a 2007-2008 Sport Trac is 50 inches, so the bed of your 2007 model is just over 4-1/2 inches narrower than that of your 2004 model. Most bed extenders are width adjustable, like the Topline # BX4004-01 bed extender you referenced. The # BX4004-01 is width adjustable from 48-62 inches wide. If that's the extender you have, it'll work just fine on your 2007 Sport... view full answer...
The part number you've mentioned with your Truxedo Series 1 tonneau cover is of a discontinued item, but my tech contact over at Truxedo says you've got 1 of 2 potential tonneau covers on your 2001 Ford Explorer Sport Trac. If you've got a decal/sticker on the rear bar above the tailgate that is not sewn into the cover/tarp and black tonneau bars/supports then you've got the Original Truxedo part number- 392601 and will want to use the Replacement Tarp for TruXedo Original Soft Truck Bed... view full answer...
It sounds like you're looking for the 6 pin adapter to plug a brake controller into your 2008 Ford Explorer Sport Trac. For that, you'll need to use part # 3035-P in most cases. If you can let me know what brake controller you're using I can confirm that this will be the correct part, or find you an alternate one that will work with your specific brake controller. view full answer...
I went ahead and looked up the owner's manual for your 2008 Ford Explorer Sport Trac and I confirmed with Ford that you can flat-tow your vehicle behind your motorhome whether you have a rear-wheel drive or a four-wheel drive model. However, it is always important to consult with the owner's manual to make sure that you abide by all other flat-towing guidelines put forward by the manufacturer. The manual discusses extra products you need for both drivetrains that are only available through... view full answer...
Craftec Tonneau cover # 153731 will fit your 2003 Ford Explorer Sport Trac. You will need to completely remove all of the parts of the old cover before you can install this new one. I have included a link to all of the Tonneau covers that fit your vehicle. view full answer...
The only front mount trailer hitch option for a 2003 Ford Explorer Sport Trac is the Curt Front Mount Trailer Hitch Receiver part # C31029 which does require drilling. That said, it's only two holes so it will be rather minor. There are no options from Draw-Tite at this time. view full answer...
I spoke with my contact at Swagman and he said the Truck Bed Mount Bike Rack part # S64702 is adjustable down to 50-1/4 inches. So if your 2008 Ford Explorer Sport Trac has a bed that measures 50 inches wide it is going to be a very tight fit.
Another option would be the Yakima BlockHead Single Bike Truck Bed Mounted Rack # Y01117. This rack is intended as a universal carrier that can fit the majority of bicycle sizes and types when mounted in a truck bed. view full answer...
If the fuses are all functioning correctly and you have traced the wiring on your 2007 Ford Explorer Sport Trac without finding the problem then I agree with you that the best option is to just bypass all of the OEM wiring with aftermarket wiring.
For your application I recommend using the Tekonsha # 119179KIT which you will splice in behind your tail lights and then route the black wire up to your battery. This kit is designed to keep the tail light wiring from being affected by any malfunctions... view full answer...
Our plows have some adjustability, but they don't have a power angle - to adjust the angle you will need to do so manually.
For your application I recommend checking out the Detail K2 Elite # K2AVAL8826ELT which installs on your 2009 Ford Explorer Sport Trac using the Curt Front Mount Hitch Receiver # 31545.
I like this snowplow because it's 88" wide x 26" tall, it has 3 different angle positions (left, center, and right), and it uses a chain-lifting design that does a great job at resisting... view full answer...
The WeatherTech All-Weather Front Floor Mats - Black # WTW11 are designed to be a close match to the vehicle configuration. These are a semi-custom fit and they will sit over your floor hooks. There are no holes to attach them, but they do stay in place. view full answer...
You will be able to use the Roadmaster Direct-Connect Base Plate Kit # 4405-3 on your 2009 Ford Explorer Sport Trac. Do note that this baseplate will not work on the Adrenalin trim.
To adapt your Blue Ox tow bars you will need the Roadmaster Adapter Kit # RO64FR to replace the ends on your tow bars so they fit the Roadmaster base plate.
You may need an adapter like the Roadmaster High-Low Adapter # RM-048-4 to level your tow bars. The tow bars should not vary by more than 3" in vertical... view full answer...
We do have trailer hitches for both vehicles, but acording to my research there are not any trailer hitches that will fit both the 2001 Ford Explorer and the 2001 Ford Explorer Sport Trac.
The recommended trailer hitch for the 2001 Ford Explorer Sport Trac is Curt Trailer Hitch Receiver # 13407. Curt Trailer Hitch Receiver # 13540 is recommended for the 2001 Ford Explorer. view full answer...
Yes, you can mount a 6x12 Tractor Tire on the Dexstar Solid Center Steel Wheel part # AM20112 no problem. The recommended wheel width for a tire that size is usually 4" so you will be good to good. The Dexstar Solid Center Steel Wheel can also be used with or without an inner tube. view full answer...
Yes, the K-Source Universal Clip-On Towing Mirror # KS3891 will fit on virtually any stock mirror like those on your 2008 Ford Explorer Sport Trac and it installs without tools. The adjustable mirror mounting arms rotate outward to accommodate different factory mirror designs and the ratcheting system securely tightens heavy-duty rubber straps to reduce vibration and image "ghosting". This mirror fits both driver and passenger side mirrors and is sold as a single unit.
For a wider field... view full answer...
If the owner's manual for your 2001 Ford Explorer Sport Trac states that you have a 500 lb tongue weight rating then you will easily be able to tow a 456 lb bike, like the 2003 V Strom 1000, on a motorcycle trailer. If you are talking about a motorcycle carrier like the etrailer # e98873 then you will likely be exceeding your tongue weight and I do not recommend going that route.
Tongue Weight (TW) refers to the downward force that the coupler of a trailer (or a bike rack or cargo carrier)... view full answer...
It sounds like you have a Global Links Door Latch Kit like part # 295-000019. The key you need is Replacement Key for Global Link RV Locks part # GL87FR to have an extra 313 key. view full answer...
I reccomend the Curt # C57WR Universal Truck Bed Exender which will fit nearly all full size pickup trucks including Chevrolet, GMC, Ford, Dodge, Ram, and Nissan, with standard 60" wide tail gates. (6.5 foot and longer beds) and provide 26-1/2 inches of additional bed length for storage and hauling. May not work with flare-style tailgates. Compatible with most tonneau covers.
I would check that measurement before ordering. view full answer...
The front hitch receiver that is designed to fit your 2007 Explorer Sport Trac is the Curt # 31545. This hitch has a 2 inch receiver opening.
The grille guard we offer for your vehicle is the Aries Grille Guard - 1 Piece - Semi-Gloss Black Powder Coated Steel, Item # AA3059.
The problem is both of these items use the same frame rail holes on your Explorer. You would need to either install the front mount hitch or the bull bar, but you will only be able to install one. You can check out... view full answer...
Go To Results